photo

Glen Tallarek


Last seen: circa un mese fa |  Attivo dal 2022

Followers: 0   Following: 0

Statistica

  • Thankful Level 2
  • First Answer

Visualizza badge

Feeds

Visto da

Domanda


How can I configure the Matlab coder to generate very simple C-code?
I have a relatively simple Simulink model that I would like to generate C-code for. When I run the code builder, I get an assor...

4 mesi fa | 1 risposta | 0

1

risposta

Risposto
Error "An input signal to a Merge block must be connected and must originate from a conditionally executed subsystem that is not an Iterator subsystem"
When I have had this problem and then read the Matlab documentation that said "must originate from a conditionally executed subs...

oltre un anno fa | 0

Risposto
How can I force the encoder to calculate both upstream branches of a switch?
I think I found a way and it seems to work. In the "Signal Properties" box and the "Logging and accessibility" tab for the ta...

oltre 2 anni fa | 0

Domanda


How can I force the encoder to calculate both upstream branches of a switch?
I have a Simulink model that has a switch block that chooses to pass the output of lookup table "A" or the output of lookup tabl...

oltre 2 anni fa | 1 risposta | 0

1

risposta

Domanda


How can I use named RAM arrays in the Simulink 1-D Interpolation block?
I am working on a automotive control project. I need to change our system control code so that a supplier can modify a calibrat...

oltre 2 anni fa | 1 risposta | 0

1

risposta

Risposto
dSPACE integration fails in Matlab
I posted this problem to the dSPACE support team and they eventually determined that I was using a version of the dSPACE Install...

quasi 3 anni fa | 1