Girisha Joshi

St. Joseph engineering Cllege

Last seen: oltre 3 anni fa | Attivo dal 2012

Followers: 0 Following: 0

Messaggio

Designation: Lecturer
working on electrical machine simulation using simulink
Professional Interests: Electrical machines and control systems

Statistica

Feeds

Domanda

Synchronising plant and controller
I am using a controller in my simulink model. how to make sure that controller works only after previous controller output (n-1)...

oltre 5 anni fa | 1 risposta | 0

1

risposta

Domanda

ABC to dq0 conversion in simulink
Hi.... I am Girisha Joshi a research scholor from NMAMIT, Nitte, Karnataka, India. I am developing a vector control model of 3 p...

oltre 6 anni fa | 0 risposte | 0

0

risposte

Domanda

AC voltage source is not giving sinusoidal output in matlab version 2010B
I have rigged up a simple circuit consisting of ac voltage source and a resistor. For run time 20ms i am getting pure sine wave....

oltre 10 anni fa | 0 risposte | 0

0

risposte

Domanda

distortions in power supply
i have developed a 3 phase power supply using cos function using simulink . Its gives distortions when i increase the run time t...

oltre 11 anni fa | 0 risposte | 0

0

risposte

Domanda

why signal generator is not giving proper sawtooth wave for frequency of 1khz and run time of 100 seconds
why signal generator is not giving proper sawtooth wave for frequency of 1khz and run time of 100 seconds

circa 12 anni fa | 1 risposta | 0

1

risposta

Domanda

how to use dot convention of transformer in simulink
how to use dot convention of transformer in simulink

circa 12 anni fa | 1 risposta | 0

1

risposta

Domanda

10kW permanent magnet synchronous machine data.....
I am developing wind energy conversion system. I am using PMSM in built model. I need corresponding values of Ld, Lq, flux link...

oltre 12 anni fa | 1 risposta | 0

1

risposta

Risposto
how to get RMalS,peak values for control algorithm from model.
Thank u so much...I used 'continuous RMS' block which gave me the RMS value,from which maximum value can also be obtained by mul...

oltre 12 anni fa | 0

Domanda

how to get RMalS,peak values for control algorithm from model.
I am developing wind energy conversion system.I am using hill climb searching algorithm for which i want to sample the inverter ...

oltre 12 anni fa | 2 risposte | 0

2

risposte

Domanda

simscape and simpower sysystem
I want to connect inverter output to variable resistor.Two blocks are in simpowersystem and simscape respectivy. how to connect?...

oltre 12 anni fa | 3 risposte | 0

3

risposte

Domanda

using .m file in simulink model
In my project, I am using simulink to model the system.Whose intermediate data has to be used in certain .m file and its output ...

quasi 13 anni fa | 1 risposta | 0

1

risposta

Domanda

data transfer b/n .m file to .mdl simulink model.
I am developing a wind energy conversion system. i would like to control the inverter current for which hill climb searching alg...

quasi 13 anni fa | 0 risposte | 0

0

risposte