photo

Nikhil


Last seen: quasi un anno fa |  Attivo dal 2023

Followers: 0   Following: 0

I am a fourth year undergraduate student at IIT Madras, in the department of Engineering Design.

Programming Languages:
Python, C
Spoken Languages:
English, Hindi, Telugu
Pronouns:
He/him
Professional Interests:
Control Systems, Automotive

Statistica

  • Knowledgeable Level 2
  • First Answer

Visualizza badge

Feeds

Visto da

Risposto
Simulink Constant Ramp Controller
Yes, It helps. You can derive the transfer function for the controller since you know the transfer function for the system and t...

circa un anno fa | 0

Risposto
One of my system that I want to control with the controller has 3 input variables as it has a disturbing vector. How can I design with matlab simulink?
Refer to this article for information on designing MIMO State Space systems : MIMO State Space Models

circa un anno fa | 0

Risposto
How do I address issue with width and dimension of PI i simulink
The error occurs because PLL block accepts only one sinusoidal signal as input. To use it for the case of three phase Voltages/C...

circa un anno fa | 0

| accettato

Risposto
using Hindsight experience replay (HER) in Matlab 2021a
No, It is not possible to use the HER syntax in a version older than 2023a, since it was introduced in 2023a.

circa un anno fa | 0

| accettato

Risposto
My ideal rotational speed sensor and ideal torque sensors are not working at the same time
Kindly check this link where a similar question has been answered. Additionally refer to this example model on how to connect ...

circa un anno fa | 0

Risposto
For the control subsystem of the Four-Switch Buck-Boost Converter, may I know what are the functions of vRef, v, FF, and Reset?
In the DC-DC Voltage Converter block, vRef is the Desired DC ouput voltage v is the measured DC output voltage FF is the fe...

circa un anno fa | 0

Risposto
How do I create a controller to stabilize an inverted pendulum in Simulink?
You can refer to this article Control of an Inverted Pendulum on a Cart which discusses how to design a PD controller for an inv...

circa un anno fa | 0

| accettato

Risposto
Simulink - Powertrain Engine Fuel in mg/injg --> kg/s
It is my understanding that you are confused about whether to input the fuel mass flow rate in kg/s or mg/inj. You should import...

circa un anno fa | 0