photo

Avinash Kumar


MVJCE

Attivo dal 2015

Followers: 0   Following: 0

Messaggio

Statistica

  • Thankful Level 1
  • First Answer

Visualizza badge

Feeds

Visto da

Domanda


Centroid of a estimated polygon
I have created a polygon using estimate geometry. I need to find the center/centroid of the polygon. I am using the below code t...

quasi 10 anni fa | 0 risposte | 0

0

risposte

Domanda


Undefined function 'selectStrongest' for input arguments of type 'uint8'.
While using the Surf feature i am getting this error "Undefined function 'selectStrongest' for input arguments of type 'uint8'."...

quasi 10 anni fa | 1 risposta | 0

1

risposta

Risposto
How to enter MATLAB code here ?
Do you want to know how to post the code in forum or in matlab???

quasi 10 anni fa | 0

Domanda


Troubleshoot controlling motors with raspberry pi model B+
With raspberry pi b+ I have connected a motor driver ic board and want to control using matlab. I am using the following command...

quasi 10 anni fa | 0 risposte | 0

0

risposte

Risposto
Arduino support package in matlab PROBLEM
if it is showing that then the setup is not done Properly and Then try a=arduino();

quasi 10 anni fa | 0

Risposto
Loop Raspi Camera board to continuously take picture
Thanks for the reply. After image is taken i am facing problem with the noise removal. The question is there in this link <http:...

quasi 10 anni fa | 0

Domanda


Command for running l293d through raspberry pi B+ in matlab r2015a
I want to run motors connected to motor driver ic board l293d. I have assigned Gpio pins 16,20 & 21. In which 16 is enable. My c...

quasi 10 anni fa | 0 risposte | 0

0

risposte

Domanda


when using bwpropfilt it show undefined function
Hi i need to filter binary image based on area and perimeter but using the command bwpropfilt (as given in matlab website) is sh...

quasi 10 anni fa | 0 risposte | 0

0

risposte

Domanda


How to remove object from binary image based on area and perimeter
Hi everyone i am trying to make a object follower comparing with a reference image. The problem i am getting is after the final ...

quasi 10 anni fa | 0 risposte | 0

0

risposte

Domanda


Loop Raspi Camera board to continuously take picture
Hi everyone I am using Raspberry Pi B+ for an object following. Since i am new to matlab, i dont know much of commands. I want t...

quasi 10 anni fa | 2 risposte | 0

2

risposte

Domanda


Unable to connect Rapberrypi B+ to MATLAB
I was trying to connect raspberry pi model B+ to my laptop using host to host connection but it shows could not detect raspberry...

circa 10 anni fa | 0 risposte | 0

0

risposte

Domanda


I was trying to connect raspberry pi model B+ to my laptop using host to host connection but it shows could not detect raspberry pi
I was trying to connect raspberry pi model B+ to my laptop using host to host connection but it shows could not detect raspberry...

circa 10 anni fa | 0 risposte | 0

0

risposte