photo

Ian


Attivo dal 2014

Followers: 0   Following: 0

Messaggio

Statistica

  • Thankful Level 1

Visualizza badge

Feeds

Visto da

Risposto
Selective plotting from .csv file
Hi Michael, Thanks again for the code. Is it possible to use this code in the form of a GUI. I made a small gui using GUIDE, bu...

circa 10 anni fa | 0

Risposto
Selective plotting from .csv file
Hi Michael, No the design number is not equal to the length. Actually there are more parameters (around 20) to select each de...

circa 10 anni fa | 0

Domanda


Selective plotting from .csv file
Hi, I've 2 sets of results from another software. Say Design1 and Design2. In each Design I've a set of X and Y values to plo...

circa 10 anni fa | 3 risposte | 0

3

risposte

Domanda


Combine all Output Graphs
Hi, I have output graphs "Torque over time" from 3 revolute joints in Simmechanics. Is it possible to combine all these graph...

circa 10 anni fa | 0 risposte | 0

0

risposte

Risposto
Contact Simulation in SimMechanics
Hi Tony, I have attched an example file. You can see the Rod passing through the wall. I tried using Rotational hardstop. Now th...

oltre 10 anni fa | 0

Domanda


Contact Simulation in SimMechanics
Hi, Is Contact simulation possible in Simmechanics 2nd gen?? I tried to understand the double wishbone suspension and i quite...

oltre 10 anni fa | 4 risposte | 0

4

risposte

Domanda


Torque and Motion actuation
Hi, Why is that I'm not getting any torque, when i actuate a revolute joint through Motion. I rotated a body from 0 to 30 deg...

oltre 10 anni fa | 0 risposte | 0

0

risposte

Domanda


Rotate - Stop - Rotate again
Hello, Is it possible to actuate a revolute joint, revolve for 3s and stop for 2s and then again start revolving? How sho...

oltre 10 anni fa | 0 risposte | 0

0

risposte

Domanda


Controlling an Input signal?
Hi, Is it possible to control an Input signal with respect to time. I have actuated a revolute joint through torque. The tota...

oltre 10 anni fa | 1 risposta | 0

1

risposta

Domanda


Is it possible to add more Input's to a Joint in SimMechanics?
Hallo, I'm simulating using Simmechanics 2nd generation. I want to rotate an object say for 2 sec and then Stop and rotate ag...

oltre 10 anni fa | 0 risposte | 0

0

risposte

Domanda


Conditional linking between 2 parts - Simulink/ SimMechanics
Hi, Is it possible to connect two parts in SimMechanics prescribing some conditions. Like I have two indivdual rotating parts...

oltre 10 anni fa | 0 risposte | 0

0

risposte

Domanda


Motion control in SimMechanics 2nd generation!!
Hi, I am using a revolute joint between two bodies. Is it possible to control the revolution, like say it should rotate only ...

oltre 10 anni fa | 0 risposte | 0

0

risposte

Domanda


Simulating an assembly in SimMechanics 2nd Generation
Hi, I have successfully translated an assembly from Pro-E to SimMechanics ( *2nd Generation* ). Its quite a huge component wi...

oltre 10 anni fa | 0 risposte | 0

0

risposte