Hendrik2k1

Last seen: 17 giorni fa | Attivo dal 2020

Followers: 0 Following: 0

Statistica

Feeds

Domanda

Unrealistic terminal voltage on Synchronous Machine Round Rotor (Simscape) when driven with a real-world DC Field Voltage
Hi everyone, I am observing unexpected scaling behavior when modeling a 5 kW, 400 V, 50 Hz synchronous machine using the Synchr...

19 giorni fa | 1 risposta | 0

1

risposta

Domanda

Stateflow implementation on Arduino very slow
I have always assumed with Simulink's Arduino support that if I have a Simulink model and declare it as “Run On Board,” all cont...

9 mesi fa | 1 risposta | 0

1

risposta

Domanda

Arduino Interrupt should only trigger Function Call Subsystem
I would like to realise a simple hardware interrupt for Arduino in Simulink. For this I use the block "External Interrupt" which...

circa un anno fa | 1 risposta | 0

1

risposta

Domanda

Multiple electrical references in Simulink/Simscape
I want to use the same electrical reference in main model in some the implemented subsystems. But even naming the reference exac...

oltre 3 anni fa | 1 risposta | 0

1

risposta

Domanda

Question on use of fft and using positive frequency values only
I have two outputs of an carried out fft from filtered signal. I now that there is only a 770 Hz sin signal left in x_filtered, ...

circa 4 anni fa | 1 risposta | 0

1

risposta

Domanda

For loop goes longer than expected.
Dear all, I want to extract a part of a colomn vector into another vector. I tried the following: startSample = Fs*startTime; ...

oltre 6 anni fa | 2 risposte | 0

2

risposte