photo

Ahmet yüksel


Last seen: 5 mesi fa |  Attivo dal 2016

Followers: 0   Following: 0

Statistica

  • Explorer
  • Revival Level 1
  • First Answer

Visualizza badge

Feeds

Visto da

Risposto
Measured rms value through Simulink with STM32F407 is varying very slowly after changing input?
Hey, I am facing the same difficulty. I am using DRMS block. If u have rectified the problem then pls let me know. how to solve ...

oltre 6 anni fa | 0

Risposto
Why the External Model of c28x_serial_ext.slx doesn't work?
tmdscockf28335 is comply with external mode ? instead of ezdsp

quasi 7 anni fa | 0

Risposto
Why the External Model of c28x_serial_ext.slx doesn't work?
as you said, ı tried tx-tx and rx-rx finally the error is continues . how to firstle use sci operation may you help me please

quasi 7 anni fa | 0

Risposto
Why the External Model of c28x_serial_ext.slx doesn't work?
ı use this cablo(https://n11scdn.akamaized.net/a1/450/elektronik/kablolar/usb-to-ttl-uart-seri-kablo-pl2303hx-1m__06614197817341...

quasi 7 anni fa | 0

Risposto
Why the External Model of c28x_serial_ext.slx doesn't work?
How to connect ezdsp f28335 external mode? Which changed you properly switches on board

quasi 7 anni fa | 0

Risposto
Why the External Model of c28x_serial_ext.slx doesn't work?
How to connect ezdsp f28335 external mode? Which changed you properly switches on board

quasi 7 anni fa | 0

Risposto
ezdsp F28335 external mode error
there is no one who can help. how to solve this problem.

quasi 7 anni fa | 0

Risposto
ezdsp F28335 external mode error
this device connect to com1 port. device ensured power. device normally with simulink gives .out file but ı want to reading adc ...

quasi 7 anni fa | 0

Risposto
ezdsp F28335 external mode error
there is no one who can help. how to solve this problem.

quasi 7 anni fa | 0

Domanda


ezdsp F28335 external mode error
ı want to use ezdsp f28335 external mode but simulink gives below error. matlab version 2017b, ccs v7 is used. out file of simu...

quasi 7 anni fa | 3 risposte | 0

3

risposte

Domanda


Strange Error of C2000 processor(F28335) in Simulink
I build all in different simulink file but .out file is given same. matlab model: 2015b(64 bit) ccsv 5.5 I used. how to s...

quasi 7 anni fa | 1 risposta | 0

1

risposta

Risposto
PWM gneration using arduino mega 2560 through simulink
Have you found any soluion to your problem, please let me know pls may you help me

quasi 8 anni fa | 0

Risposto
How to change pulse width modulation FREQUENCY of arduino analog pins with new support package for R2014b?
ı want to change arduino pwm freqaucny in MATLAB SIMULINK, how to do this, thank you a lot..

quasi 8 anni fa | 1

Risposto
Arduino and Simulink / change PWM frequency
hello I have the same problem, Can you please tell me if you succeded to solve it.... Thank you for all

quasi 8 anni fa | 0