photo

owen chang


Last seen: circa 5 anni fa |  Attivo dal 2013

Followers: 0   Following: 0

Messaggio

Statistica

  • Thankful Level 1

Visualizza badge

Feeds

Visto da

Domanda


why exportONNXNetwork will add additional "Sub" in onnx, how to remove this layer in onnx?
Hi, i did the following: >> baseNetwork = resnet50; >> exportONNXNetwork(baseNetwork,'resnet50-matlab'); but when compare sam...

oltre 5 anni fa | 1 risposta | 0

1

risposta

Domanda


how to deploy deep learning prototype to FPGA using HDL Coder?
Hi i have FPGA platform and like to play around with Matlab deep learning (like MatConvNet), then deploy on my FPGA platform fo...

oltre 7 anni fa | 1 risposta | 0

1

risposta

Domanda


running open_system('hdlcoder_led_blinking') for zynq, but no connection?
Hi, i am using usb jtag cable for communication with zynq-zc702, but i can't see serialport as instructed in the webinar, how sh...

circa 11 anni fa | 1 risposta | 0

1

risposta

Domanda


how could i generate an axi-stream or axi4-lite dma master by hdl coder?
Hi, i found the current demo using only axi-stream slave interface in sobel image processing system. however, it might require a...

oltre 11 anni fa | 1 risposta | 0

1

risposta

Domanda


HDL Stream FFT in HDL Coder 2013b, not support AXI4-Stream Interface? (single rate?)
Hi, i have built a system involving Stream FFT with AXI4-Stream Interface, the goal is to put this design into Zynq, so AXI4-St...

oltre 11 anni fa | 1 risposta | 0

1

risposta

Domanda


Failed Streaming interface is not supported when the DUT is not single rate
Hi, the AXI-Stream interface for Stream FFT is requiring DUT "single rate", but i can't find where to set it, and what does it ...

oltre 11 anni fa | 0 risposte | 0

0

risposte

Domanda


HDL Stream FFT in HDL Coder 2013b, not support FPGA?
Hi, i am using Stream FFT for Zynq, but once i have created the subsystem and set it to Atomic, i have this error message pop u...

oltre 11 anni fa | 1 risposta | 0

1

risposta

Domanda


How to create a FFT ipcore for Zynq using Simulink HDL Coder?
there is an error message "not support for frame based module"? is there any other solution for exporting signal processing bl...

oltre 11 anni fa | 2 risposte | 1

2

risposte

Domanda


Does HDL coder from Simulink support AXI-4 Stream Interface for Xilinx Zynq?
Hi all, I have created an adder example and export to Xilinx Vivado 2013.2 using HDL coder, and integrated using Vivado IPI. th...

oltre 11 anni fa | 1 risposta | 0

1

risposta