bno055 System "uncalibrated"
11 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
I was working with my adafruit bno055, and tried to interface it with matlab. I was able to interface both my Uno and my bno055 sensor. I followed the matlab's documentation page to calibrate the bno055 senor. and used the readCalibration status command to see how it went. I got this message on my terminal. I got the following message...
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/807549/image.png)
I also followed the offical matlab's tutorial on how to connect the bno055 with matlab in their website. The question is how do I get the system status to be calibrated ?. I also was able to get the sensor system to be fully calibrated using Arduino's IDE. So I know that I didn't recive a fauly bno055 senor.
3 Commenti
Risposte (2)
Gayatri Menon
il 13 Mar 2022
Hi
Have you tried the calibration steps as mentioned in the below doc
Thanks
Gayatri
0 Commenti
Germano Gallicchio
il 16 Mar 2022
Modificato: Germano Gallicchio
il 16 Mar 2022
Have you found a solution? If not, try using the 'Adafruit/BNO055' library instead of the 'I2C'. Initially, I was getting the same error as you. Now I can calibrate the System to 'full'.
arduinoObj = arduino('COM7', 'Micro', 'Libraries', 'Adafruit/BNO055');
I am using MATLAB version 2020b. The 2021b version of the Arduino package does not include the 'Adafruit/BNO055' library.
0 Commenti
Vedere anche
Categorie
Scopri di più su I2C Devices in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!