How can I use multimeter in the sequential circuit design with Xor gate and measure power in microwatts?
2 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/146159/image.png)
I am designing a sequential circuit using XOR gate in matlab2014 but when I ran the following errors occurs:
1. Invalid setting for input port dimensions of 'AHpower/Demux'. The dimensions are being set to [-1]. This is not valid because the total number of input and output elements are not the same. Component: Simulink | Category: Block error
2. Error in port widths or dimensions. Invalid dimension has been specified for output port 1 of 'AHpower/Multimeter'. Component: Simulink | Category: Block error How can I solve these errors?
1 Commento
Joel Van Sickel
il 13 Ott 2023
can you share your model? It probably has to do with how the multi-meter is set up and I can't tell just from the screenshot.
Risposte (0)
Community
Più risposte nel Power Electronics Control
Vedere anche
Categorie
Scopri di più su Simscape Electrical in Help Center e File Exchange
Prodotti
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!