how do i make this pv model work
7 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
I am trying to simulate a pv cell but the current controlled source block is giving the error "The 'CCS' block cannot be left open-circuit because it is modeled as a current source. You should try to resolve the open-circuit topology or delete this block from your model." How do I resolve this and make the circuit work.
1 Commento
Joe Jones
il 21 Set 2023
I have the same error. Can you tell me the solution to this error?Thank you very much.
Risposte (3)
A Jenkins
il 12 Mar 2015
Close the circuit. You say you have a source of current, so where does that current go? Perhaps a resistor as a load?
0 Commenti
anbumani p
il 22 Gen 2023
The 'Controlled Current Source' block cannot be left open-circuit because it is modeled as a current source. You should try to resolve the open-circuit topology or delete this block from your model.
Xing
il 24 Lug 2023
I have the same question. Even I give a constant value by Simulink block and connect the controlled current source block and also the two electrical ports are already connected. I got the same error.
0 Commenti
Vedere anche
Categorie
Scopri di più su Sources in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!