Xilinx ZCU102 not booting with pre-built image
18 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
SW6 is set in SD boot mode (https://de.mathworks.com/help/hdlcoder/ug/getting-started-with-hardware-software-codesign-workflow-for-zynq-ultrascale-mpsoc-devices.html)
First tried building linux image with the automated process in "Embedded Coder Support Package for Xilinx Zynq Platform"
Test results from serial port:
"PMU-FW is not running, certain applications may not be supported"
Second, tried the pre-built linux images from github: https://github.com/mathworks/buildroot/releases/tag/mathworks_zynq_R23.1.0
Again same test results from serial port:
"PMU-FW is not running, certain applications may not be supported"
0 Commenti
Risposte (1)
Kiran Kintali
il 13 Ott 2023
This could be FSBL related error unrelated to HDL Coder. Found several references here. I will try to research a bit more. Please check if any of the results make sense to you.
2 Commenti
Kiran Kintali
il 17 Ott 2023
1.1. Make sure the SW6 switch is set as shown in the figure below, so you can boot up Linux from the SD card.
In addition to the image specifying switch settings might be helpful. I have communicated this feedback to HDL Coder documentation team.
Vedere anche
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!