- Ensure Proper Power Supply Connection: Verify that the 24V DC power supply is correctly connected to the inverter board. Check all connections for any loose wires or poor contacts.
- Activate the Power Supply Before Simulation: Confirm that the power supply is turned on and providing a stable output before starting the simulation. This ensures that the inverter board is powered throughout the simulation process.
Under voltage error occurred while estimating PMSM parameters using TI LaunchPad 28379D and Boost pack 8305
2 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
While performing the same in 2023a I got the serial communication error. Then I've installed 2023b and the simulation was performed. I received Undervoltage error. This is the error message.
Error:An error occurred while running the simulation and the simulation was terminated
Caused by:
Under-voltage detected.
Error in 'mcb_param_est_host_read/Algorithm/SignalConditioning/ErrorConditions' (line 23)
(error(message('mcb:blocks:UnderVoltageDetected')));
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/1645881/image.png)
0 Commenti
Risposte (1)
Kautuk Raj
il 22 Apr 2024
Hi Saathwik, I can understand that encountering an under-voltage error while estimating PMSM parameters using the TI LaunchPad 28379D and Boost pack 8305, especially after updating from MATLAB 2023a to 2023b.
The error message indicating an under-voltage condition suggests that the system is not receiving sufficient voltage to perform the desired operations, which is often related to the power supply setup.
To address this issue, consider the following steps:
Following these steps should help resolve the under-voltage error.
0 Commenti
Vedere anche
Categorie
Scopri di più su Motor Control Blockset in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!