How to change pole configuration for Commutation of SRM Using Sensor Feedback example?

The Commutation of SRM using sensor feedback in this example uses a 12/8 SRM motor configuration using TI F28379D. Is it possible to change the poles to configure it for a 6/4 SRM motor instead? If so, how can the configuration be modified in the Simulink example?

Answer 1

[praguna manvi]

Hi @RK,

As I understand, you are referring to the example of “Commutation of SRM Using Sensor Feedback” available at this link:

https://www.mathworks.com/help/mcb/gs/commutation-srm-using-sensor-feedback.html

To change the pole configuration, you can set the “Three-phase SRM” block’s number of rotor poles to 4 in the “Power Converter and Motor” subsystem of the example as shown here

For additional information on the “Switched Reluctance Machine,” refer to this link:

https://www.mathworks.com/help/sps/ref/switchedreluctancemachine.html

Hope this helps!