Is there a way to guaranteed floating point accuracy between MATLAB and SIMULINK?
4 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
I run the same code in MATLAB and SIMULINK (MATLAB Embedded Block) and at times get slightly different results. I notice it is because of floating point accuracy where at times I may get a 1e-30 difference in a calculation and then that propagates through. I've read a little about variable precision arithmetic but it isn't supported in code generation for SIMULINK. So I am stuck with a problem where I cannot reliably produce the same answers in two environments using the same initial conditions and algorithm.
0 Commenti
Risposte (1)
Sebastian Castro
il 21 Set 2015
The discrepance should depend on the numerical solver you are using in MATLAB vs. Simulink. This includes the type of solver, step-size options, tolerances, and so on.
For example, if you are using variable-step solvers like ode45, you should match the model configuration parameters against the odeset options in the programmatic approach.
If you configure them to be identical to each other, the results should match up too.
- Sebastian
5 Commenti
Walter Roberson
il 24 Set 2015
Your other question about this dealt with calling the same inv() routine, on the same data, so the explanation for it is something different, such as the state of the floating point rounding controls.
Vedere anche
Categorie
Scopri di più su Sources in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!