How can i change the output power of a wind turbine induction generator in simpowersystems, and how can I measure the output power?
3 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
Hello I've been trying to change the output power of a wind turbine induction generator from its menu window (shown below), but I can't figure out the change in power in the scopes I can't understand the resulting signals after I changed the nominal power.
Appreciate your help
0 Commenti
Risposte (2)
Joel Van Sickel
il 17 Set 2020
Hello Qais,
you will also need to increase the power delivered to the motor. This will show up in the simulation as increase voltage and current.
Regards,
Joel
0 Commenti
Ibrahim Athamnah
il 3 Gen 2022
Hello Qais,
I have almost the same problem.
If you solve it, please send to me the solution. My email is:
2019979009@ses.yu.edu.jo
0 Commenti
Vedere anche
Categorie
Scopri di più su Wind Power in Help Center e File Exchange
Prodotti
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!