How to stop a function? Simulink.

Hello,

This is what I want to do, I am working on simulink, I have a function (M-file), I have one input, if this input is equal to "1" the M-file start and when the input change to "0", I want to stop this M-file (and reset all the values) until the input change again to 1 and start the excecution as the first time.

Some how the "IF" block of simulink only make the change but the M-file continue being executed.

I can not use the pause command because Its stop all the simulation And I only want to stop the execution of this M-file.

I hope u understand me, I wait for your help. Thanks.

Answer 1

[Kaustubha Govind]

I think you need to out your M-file inside an Enabled Subsystem and use your input as the control signal for the subsystem, so that your M-file is executed only when the subsystem is enabled.

[Ana]

I Will try, Thanks!