Can BrickPi be programmed from Matlab/Simulink to control LEGO NXT sensors and motors?
2 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
Gautam Goel
il 2 Gen 2017
Commentato: Jannik Hahn
il 12 Mar 2021
Hi, Has anyone tried controlling LEGO NXT sensors and motors via BrickPi over Raspberry Pi 3's on-board WiFi? BrickPi is essentially an expansion board to Raspberry Pi: https://www.dexterindustries.com/BrickPi/.
BrickPi officially does not support Matlab/Simulink yet. I am wondering if anyone can point me to relevant resources to help figure out how to access and control these motors and sensors. Thanks, Gautam
1 Commento
René van der Meer
il 24 Dic 2017
Gautum, this is a very good idea! I would love to use this as well. I hope that someone already has done this. Otherwise would could start with the Dexter SW?
Risposta accettata
Jannik Hahn
il 9 Dic 2019
Hi Gautam,
maybe a bit late, but you can use the "Simulink Support Package for Raspberry Pi Hardware" and control the motors and sensors via SPI. I actually use the "SPI Master Transfer" and extract the needed inputs from the c++ libraries provided by Dexters BrickPi3-master.
Cheers Jannik
6 Commenti
Più risposte (0)
Community
Più risposte nel Power Electronics Control
Vedere anche
Categorie
Scopri di più su LEGO MINDSTORMS EV3 Hardware in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!