RTP buildRapidAcceleratorTarget with S-functions
3 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
Hello,
I am trying to get the RTP Parameters from an S-Function with more than 10 tunable parameters. The S-Function has a mask with the paramters listed (10 parameters each page). When using the command buildRapidAcceleratorTarget, only the first page (parameters 1-10) is recognized and written to the rtp struct (rtp.parameters.map).
I am using Matlab 2015b 64-Bit. I already tried to Switch the page in the S-function mask and save the model --> result was no recognized Parameters at all.
mdl = 'sfcn';
rtp = Simulink.BlockDiagram.buildRapidAcceleratorTarget(mdl);
Any further ideas?
Thanks Sebastian
0 Commenti
Risposte (1)
Saurabh Gupta
il 30 Gen 2017
Make sure all your mask parameters are tunable and registered as run-time parameters in your S-function. You may find the Run-Time Parameters documentation page helpful.
If you are using C S-function, you can use ssGetNumRunTimeParams and ssGetRunTimeParamInfo SimStruct functions to verify that all the required parameters are registered.
Vedere anche
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!