remove error message in command window
36 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
How to remove error message in command window matlab if we don't want the message to appear?
Is this possible?
note: I'm using m-file
Thanks before..
1 Commento
Stephen23
il 11 Mag 2017
Modificato: Stephen23
il 11 Mag 2017
Once the error message has been displayed in the command window there is not much that can be done about it, other than clearing the whole command window using clc. It might be easier to prevent it getting displayed in the first place: see the documentation for catch.
Risposta accettata
Jan
il 11 Mag 2017
error message are very important. Because they should never be ignored, it is a bad idea to remove them. A much better idea is to either avoid them, by considering the reasons, or to handle them in a TRY/CATCH block.
2 Commenti
Image Analyst
il 12 Mag 2017
Are you sure it wasn't a warning (orange type instead of red)? Otherwise your program would not have finished (unless the error-causing code was in a try block).
Più risposte (0)
Vedere anche
Categorie
Scopri di più su Simulink Functions in Help Center e File Exchange
Prodotti
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!