I would like to plot a sample graph (a rough stress strain curve comparison) with 2 lines where my x,y and instantaneous slopes are known...and basically very roughly interpolate the curve between the two. is this possible?
Hint: Suppose your interpolated curve is the following general cubic polynomial with four unknown coefficients:
y = a*x^3+b*x^2+c*x+d
Its slope (derivative) would be:
s = 3*a*x^2+2*b*x+c
Using these two equations, you can write four linear equations that must be satisfied for each of your curves. In each case matlab can solve those four equations for the unknown a, b, c, and d values, and you then have your two interpolated curves (not "lines".)
Thank you, but I'm not sure how to turn the points and slopes I have into a plot given that information. (grey-haired researcher, new to Matlab here...trying to represent some pilot data in graphical form).
Use the two end y values in the first equation and the two end slope values in the second equation. This gives you your four linear equations in the unknown coefficients a, b, c, and d, which matlab can solve for you. Do this for each curve.
Impossibile completare l'azione a causa delle modifiche apportate alla pagina. Ricarica la pagina per vedere lo stato aggiornato.
Translated by
Seleziona un sito web
Seleziona un sito web per visualizzare contenuto tradotto dove disponibile e vedere eventi e offerte locali. In base alla tua area geografica, ti consigliamo di selezionare: .
Puoi anche selezionare un sito web dal seguente elenco:
Come ottenere le migliori prestazioni del sito
Per ottenere le migliori prestazioni del sito, seleziona il sito cinese (in cinese o in inglese). I siti MathWorks per gli altri paesi non sono ottimizzati per essere visitati dalla tua area geografica.