How to implement intermittent contact using SimMechanics (e.g. Geneva wheel)?
1 visualizzazione (ultimi 30 giorni)
Mostra commenti meno recenti
Is this possible? Any suggestions on how to model an intermittent contact of this sort are much appreciated.
0 Commenti
Risposta accettata
Ryan G
il 25 Lug 2012
1) Model the 'driver' Wheel directly, connect to ground via revolute
2) Model 'Driven' Wheel directly, connect to ground via revolute
3) connect the Driven wheel to the point sticking up from the Driver wheel via point curve constraint.
4) Design the pattern of the Driven wheel inside the point curve constraint.
This should be straightforward once you get the pattern figured out.
2 Commenti
Più risposte (1)
Vedere anche
Categorie
Scopri di più su Simscape Multibody in Help Center e File Exchange
Prodotti
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!