Field oriented control on Zynq Zedboard without the FMCMOTCON2 module.
4 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
Zaeem Gauher
il 21 Giu 2019
Risposto: Joel Van Sickel
il 18 Ago 2020
I am trying to implement the Field oriented motor control example found here: https://www.mathworks.com/help/supportpkg/xilinxzynq7000ec/examples/field-oriented-control-of-a-permanent-magnet-synchronous-machine.html
I do not have the FMCMOTCON2 driver module that comes with the kit ( I have the Zedboard and the Dyno). Can I use another driver board such as the Enclustra FMC DR2? If so, do I need to change any parameters in the simulink model for this example?
0 Commenti
Risposta accettata
Joel Van Sickel
il 18 Ago 2020
Hello Zaeem,
You can use the fundament control algorithm with any driver, assuming that driver is appropriately speced for your system. Assuming you are only changing the driving hardware, most parameters in the simulink model will not need to change. However, you will need to investigate the interface to the new driver and make sure that all signals are scaled/typed appropriately and the signals go to the correct i/o channels, as the interface is probably somewhat different.
Regards,
Joel
0 Commenti
Più risposte (0)
Vedere anche
Categorie
Scopri di più su Hardware-in-the-Loop Simulation with Simulink Real-Time in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!