Run Simulink continuously with NI-DAQ
2 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
Hi,
I need to run the acquisition by DAQ continuously with external analog input.
I tried with Analog Input block from Data Acquisition Toolbox (it finds DAQ automatically and allows to set Sample rate, channels, etc...), but at stop time, obviously, acquisition turns off.
In Real-time windows target (analog input block), if i check among Data Acquisition Board there's not my DAQ (NI-6020E).
How can i make it acquire signals by DAQ?
0 Commenti
Risposte (2)
Arnaud Miege
il 12 Apr 2011
If the Data Acquistion Toolbox is fast enough for you, you can set the stop time to Inf, and it'll keep going until you manually stop it.
HTH,
Arnaud
4 Commenti
Arnaud Miege
il 16 Apr 2011
Yes, it should do, unless you run out of memory or the buffer gets full. I imagine that the data coming from the DAQ card fills up a buffer which gets read by the software.
Kaustubha Govind
il 12 Apr 2011
For use with Real-Time Windows Target, you can only use boards that are in the Supported Hardware List.
If you don't see your device here, you can submit an enhancement request with Tech Support so your board can be considered for support in a future version of the software.
0 Commenti
Vedere anche
Categorie
Scopri di più su Hardware-in-the-Loop Simulation with Simulink Real-Time in Help Center e File Exchange
Prodotti
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!