- Apply a torque pulse to get it spinning... OR
- Assign damping to one of the Revolute Joints... OR
- Use a motion input to ONE of the gears
Incorrect velocity of gears in Gearbox
3 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
Hi everyone,
So I'm a building a single stage gearbox as depicted in the figure below in Simulink.
Gear 1 (N = 17 teeth) is given a constant torque of 1000 Nm and meshed with gear 2 (53 teeth).
When I run the simulation I get a ridiculously high velocity profile for either gear that keeps increasing as time passes. Should this value not remain constant? What am I missing that could possibly cause this?
Any help is appreciated!
0 Commenti
Risposte (1)
Steve Miller
il 20 Dic 2022
The simulation results you have plotted are correct. You are applying a constant torque to both gears. Applying a constant torque to a rotational system with no damping will result in a system that just keeps accelerating (Torque = Inertia* Acceleration). If you want it to settle at a constant speed, you need to do one of the following:
--Steve
0 Commenti
Vedere anche
Categorie
Scopri di più su Joints and Constraints in Help Center e File Exchange
Prodotti
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!