How to enable the signal visualization blocks in the "QPSK Receiver with ADALM-PLUTO Radio" example?
2 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
MathWorks Support Team
il 15 Dic 2020
Modificato: MathWorks Support Team
il 18 Apr 2024
I am trying to use the signal visualization blocks found in the following example (QPSK Receiver with ADALM-PLUTO Radio):
However, I can not find a way to activate these signal visualization blocks as the process to do so is not mentioned in the example documentation.
I had noticed that one sentence in the doc says, "To ensure real-time processing, the model is by default set to run in Accelerator mode, and to remove all signal visualization", but when I tried running the model in Normal mode there was no change. How do I activate these blocks?
Risposta accettata
MathWorks Support Team
il 18 Apr 2024
Modificato: MathWorks Support Team
il 22 Dic 2021
In the example model, if you double click on the QPSK receiver block, you will see the spectrum analyzer and constellation diagram blocks (4 blocks in total) as shown below.
Please right-click on each of these blocks and select 'Uncomment'. Uncommenting all these four blocks should show you the visualizations.
0 Commenti
Più risposte (0)
Vedere anche
Categorie
Scopri di più su RF Component Modeling in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!