Simulink with AWGN channel
1 visualizzazione (ultimi 30 giorni)
Mostra commenti meno recenti
I try to simulate this function: y(t)= Acos(2πfc +) f€<0-1kHz>, €<0,45°>, A=0,5
in simulink via awgn channel, but nowhere did I find a cosine block in simulink where I can enter my parameters, but I tried the waveform generator block, where I wrote these parameters and released this signal via trigonometric function into awgn channel and I saw it on scoope. Do you think it's a bad idea?
0 Commenti
Risposte (1)
Pavan Guntha
il 29 Mar 2021
Hi Jozef,
You can refer to the documentation of sine wave block in Simulink. It supports the parameters like amplitude, frequency, phase and bias. A possible workaround to use this block is to appropriately add the 90 degree phase offset to the offset value you are interested in to obtain the cosine function from that block (since cosine and sine vary in phase by 90 degrees).
Hope this helps!
0 Commenti
Vedere anche
Categorie
Scopri di più su RF Blockset Models for Transceivers in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!