Why is there an error displayed on my target machine after I boot the machine using the boot disk created by my host machine using xPC Target 2.5 (R14)?

Question

MathWorks Support Team il 27 Giu 2009

0
Link

Link diretto a questa domanda

https://it.mathworks.com/matlabcentral/answers/94455-why-is-there-an-error-displayed-on-my-target-machine-after-i-boot-the-machine-using-the-boot-disk-cr

Modificato: MathWorks Support Team il 25 Feb 2014

Risposta accettata: MathWorks Support Team

I create the boot disk and booted the target machine and see the following errors:

ERROR: -4: drive not found

or

No accessible disk found: file system disabled

Accedi per rispondere a questa domanda.

Answer 1

MathWorks Support Team il 18 Ott 2013

0
Link

Link diretto a questa risposta

https://it.mathworks.com/matlabcentral/answers/94455-why-is-there-an-error-displayed-on-my-target-machine-after-i-boot-the-machine-using-the-boot-disk-cr#answer_103807

The xPC Target 2.5 (R14) has a new feature which supports writing real-time data to a disk file on the target system also called File Scope. This feature is limited to IDE hard drives formatted in FAT. Hard drives formatted in NTFS or hard drives that use other interfaces (such as SCSI or DiskOnChip) are not supported currently. The error message indicates the inability of the kernel to locate a FAT hard disk. It can be safely ignored, if you do not plan on using the File Scope feature.