How can I use Matlab command line to open/close signal viewer interfaces in Simulink 7.8 (R2011b)?
2 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
MathWorks Support Team
il 12 Dic 2011
Commentato: Cory Dinkle
il 20 Dic 2021
I have a signal viewer attached to a signal line in my Simulink model. I want to open and close this signal viewer through MATLAB command line interface. I do not want to interact with the Simulink interface by double clicking on its symbol on the model. I have subsystems in my model and the signal viewer could be attached to any level in the model.
Risposta accettata
MathWorks Support Team
il 12 Dic 2011
Consider the model 'testMdl.mdl'. There is a viewer named "MyViewer" in the top layer of the model and there is another viewer named 'ViewerInSubsystem' inside the subsystem. I can open and close these viewers from MATLAB command line using the following code:
>> mdl = 'testMdl';
>> open_system(mdl);
>> set_param( [mdl '/MyViewer'],'open','on');
>> set_param( [mdl '/ViewerInSubsystem'],'open','on');
>> set_param( [mdl '/MyViewer'],'open','off');
>> set_param( [mdl '/ViewerInSubsystem'],'open','off');
However deep the signal viewer is in the model, they can always be accessed programmatically by specifying the model name and the signal viewer name. It is not necessary to point to the location where the viewer exists in the model.
1 Commento
Più risposte (0)
Vedere anche
Categorie
Scopri di più su Programmatic Model Editing in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!