Statistica
RANK
135.824
of 299.984
REPUTAZIONE
0
CONTRIBUTI
7 Domande
1 Risposta
ACCETTAZIONE DELLE RISPOSTE
28.57%
VOTI RICEVUTI
0
RANK
of 166.841
CONTRIBUTI
0 Problemi
0 Soluzioni
PUNTEGGIO
0
NUMERO DI BADGE
0
CONTRIBUTI
0 Post
CONTRIBUTI
0 Pubblico Canali
VALUTAZIONE MEDIA
CONTRIBUTI
0 Punti principali
NUMERO MEDIO DI LIKE
Feeds
Domanda
Do the additional delays added by adaptive pipeline distroy the alignment between signal paths?
Hi, I want to use adaptive pipeline to optimize the multiply-add module in HDL coder for xilinx FPGA. I enable adaptive piplin...
10 mesi fa | 1 risposta | 0
1
rispostaHDL Coder reset control
Hi Androw I want to find out all the delay module with "default reset". I use following command, but it is failed. do you have ...
oltre un anno fa | 0
Domanda
mapping lookup table to block ram
I use HDL coder, lookup table block. and enable the option to map look up table to RAM. I have add a piple register right at th...
quasi 2 anni fa | 1 risposta | 0
1
rispostaDomanda
HDL simulation logic analyzer is slow
my logic analyzer in HDL simulation is slow. can graphic card help on it or adding more grafic memery?
quasi 2 anni fa | 0 risposte | 0
0
risposteDomanda
HDL "complex to Magnitude and angle" module show critical path which can not meet 160MHz clock timing
Hi, experts I try to use the module of "complex to Magnitude and Angle (CMA)" on xilinx FPGA with clock of 160MHz. the critica...
oltre 2 anni fa | 1 risposta | 0
1
rispostaDomanda
timing control module _tc.v have failed path to other module
my HDL code from HDL codeGen has timing error. Some of the failed path are from module _tc.v to other modules. in the tc.v mod...
oltre 2 anni fa | 0 risposte | 0
0
risposteDomanda
wlanhdlreceiver use only 64 sample to do fine symbol timming. is it enough for 40M, 80M and 16MHz wlan signal?
I am learning on the wlanHDLReceiver HDL design. the Design uses 64 data to do fine symbol timing. But in Matlab .m reference de...
oltre 2 anni fa | 1 risposta | 0
1
rispostaDomanda
evm demoded from wlan ofdm signal with comm.Phasenoise() increased round 3dB from 80MHz to 160MHz signal bandwidth.
Hi, I am using a comm.Phasenoise to check the phase noise effect on EVM for a demoduation of wlan ofdm signal. the simulation...
oltre 2 anni fa | 0 risposte | 0
