Statistica
RANK
263.329
of 300.780
REPUTAZIONE
0
CONTRIBUTI
6 Domande
2 Risposte
ACCETTAZIONE DELLE RISPOSTE
66.67%
VOTI RICEVUTI
0
RANK
of 171.018
CONTRIBUTI
0 Problemi
0 Soluzioni
PUNTEGGIO
0
NUMERO DI BADGE
0
CONTRIBUTI
0 Post
CONTRIBUTI
0 Pubblico Canali
VALUTAZIONE MEDIA
CONTRIBUTI
0 Punti principali
NUMERO MEDIO DI LIKE
Feeds
Domanda
Problems getting Master Transfer Block to function
I would welcome a pointer to some clearer documentation for the c28x SPI Master Transfer block in provided for TI MCU for use in...
circa 3 anni fa | 1 risposta | 0
1
rispostaDomanda
SPI interface timing with deasserts
I'm looking for a way to read data from a Si8380S-IU chip from a TI F2337xD based processor. The Simulink examples for Master T...
circa 3 anni fa | 0 risposte | 0
0
risposteDomanda
Problem with external mode and model running on target hardware
When attempting to connect a model running on the target hardware I encounter "External mode simulation is not supported for mod...
circa 3 anni fa | 1 risposta | 0
1
rispostaHow to concatenate array of signal values in a for loop block in simulink with himself Indefinite number of times
Had the same issue, resorted to the following, which is not much use for a larger number of values, but it did mean I could add ...
oltre 3 anni fa | 0
Domanda
Errors when examining CAN log output in Mathworks
I'm getting an error "Reference to non-existent field 'x_440V_Tripped' when attempting to load a CAN log file from a simulation ...
oltre 3 anni fa | 1 risposta | 0
1
rispostaDomanda
Ordering of CAN signal ports, when CAN Pack/Unpack is using "CANdb specified signals"
Regardless of the order in the CANdb file or the bit order assigned to signals, CAN unpack will show its outputs in alphabetical...
oltre 3 anni fa | 1 risposta | 0
1
rispostaUnclear error message for Swicth-Case Action on model update
Loss of access to the reference sub system location caused all the connections to become 'disconnected' even though the lines re...
oltre 3 anni fa | 0
| accettato
Domanda
Unclear error message for Swicth-Case Action on model update
The error message "The action port on subsystem '......../Chip1_WriteBytes1' can only be connected to an If or Switch-Case and m...
oltre 3 anni fa | 1 risposta | 0
