Community Profile



Last seen: 9 giorni fa Attivo dal 2016


  • Solver
  • Revival Level 1
  • First Answer

Visualizza badge

Content Feed

Visto da


Make the vector [1 2 3 4 5 6 7 8 9 10]
In MATLAB, you create a vector by enclosing the elements in square brackets like so: x = [1 2 3 4] Commas are optional, s...

circa 5 anni fa


Times 2 - START HERE
Try out this test problem first. Given the variable x as your input, multiply it by two and put the result in y. Examples:...

circa 5 anni fa


How is the CAN Pack block from Simulink Real Time triggered to send remote frames?
I've used this block before for non-remote frames inside Switch Case Action Subsystems but for remote frames it does not send t...

oltre 6 anni fa | 1 risposta | 0



Ambiguous sorted order detected due to use of triggered subsystem(s) in a loop. See Subsystem Examples in the Simulink library for valid and invalid examples of triggered subsystem
I've experienced the same issue because the trigger signal depended on the output of the subsystem. If this was your problem, th...

oltre 6 anni fa | 1