photo

Paul

MathWorks

Attivo dal 2016

Followers: 0   Following: 0

Messaggio

Statistica

All
  • Knowledgeable Level 2
  • First Answer
  • Solver

Visualizza badge

Feeds

Visto da

Risposto
How to control GPIO of ARM on Zedboard
There currently is no support for GPIOs on a Zedboard from the ARM. LEDs and DIP switches are connected to the FPGA, you can ...

circa 6 anni fa | 0

Risposto
Chang center frequency quickly
* It is possible to change the CenterFrequency property while the System object is locked as it is a tunable property. Give a l...

circa 6 anni fa | 0

Risposto
The received signal from sdrrx keeps unchanged even if I connect or disconnect the loopback cable to trainsmitter port TxA and receiver port RxA
Hi Ardeal, There is enough leakage between the unconnected RF connectors to lead to the results you are seeing on the example...

circa 6 anni fa | 0

| accettato

Risposto
Run transmitter and receiver model in 1 model or 2 separate model in parallel
Hi Ardeal, The answer I gave to your other post should cover this question too. <https://uk.mathworks.com/matlabcentral/answe...

circa 6 anni fa | 0

| accettato

Risposto
Question about how to run TX and RX calibration example model on zedboard with zynq
Hi Ardeal, Transmit and receive on one same hardware using Tx and Rx blocks is not recommended. As both documentation link yo...

circa 6 anni fa | 0

| accettato

Risposto
Zynq Radio Software Interface Model: UDP send/receive blocks not working
Thanks for the details Harry. About the loopback cable: you will have enough leakage from the unconnected antennas for them t...

oltre 6 anni fa | 1

Risposto
Zynq Radio Software Interface Model: UDP send/receive blocks not working
Hi Harry, The setup details you are providing are correct. The Ethernet port you are currently using will be fine if it is th...

oltre 6 anni fa | 1

| accettato