Community Profile

photo

maarten de Jong


Last seen: oltre 3 anni fa |  Attivo dal 2016

Followers: 0   Following: 0

Statistiche

  • First Review

Visualizza badge

Feeds

Visto da

Domanda


A negative input value for integrator gives a positive output
I have a simulink continuous integrator block with a lower limit output saturation at zero. It takes a negative input and produ...

quasi 4 anni fa | 0 risposte | 0

0

risposte

Domanda


Why can`t I use the PID block anymore?
Upon restartin my Simulink model, I get the warning (5 times, 1 time for every PID-block) Attempt to load model file 'C:\Prog...

quasi 4 anni fa | 0 risposte | 0

0

risposte

Domanda


Why does simscape block controlled reservoir (G) require T input to be Delta K instead of K?
I keep getting the warning : Output port 1 of 'Prereformer_SOFC/SOFC/From' sends a signal of unit '1', but input port 1 of 'Pre...

circa 4 anni fa | 0 risposte | 0

0

risposte

Domanda


Where would I find properties of steam, to use in the gas properties block in simscape?
I am working on a system that uses compressors for different flows. One for stem, one for methanol and one for a mixture. This i...

circa 4 anni fa | 1 risposta | 0

1

risposta

Domanda


invalid use of matlabfunction 'tablelookup' in simscape component
I keep getting an error when I try to run a simle electrical circuit with my custom resistor connected. The error occursin th...

circa 4 anni fa | 1 risposta | 0

1

risposta

Domanda


Error: Class member redefinition has been found
I have been trying to define a resistor which also produces heat in simscape. The code for the .ssc file is depicted below. When...

oltre 4 anni fa | 0 risposte | 3

0

risposte

Domanda


How do i get the position of the minimum value in at 3 dimensional array?
If I have a 3 dimensional array, an I want to find the position of the minimal value of that array, preferably in vector form, w...

oltre 7 anni fa | 1 risposta | 0

1

risposta