How to do a hydraulic valve model (valve of mud pump)?
2 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
Hello everyone,
I am trying to do predictive maintenace of triplex mud pump. I have to use vibration sensor( similar to Transmission System Model in Matlab.) to detect swab failure from vibration data.I have to place the vibration sensor on the mupump as shown in below figure. How I can create a simulink model of the valves?
This is the valve. How to model this??
Any help will be highly appreciated.
Thanks in advance.
Thanks and regards,
Aleena N A
2 Commenti
Sam Chak
il 25 Mar 2022
Hi @aleena n a
Are you looking for a methematical model like ODE that describes the nonlinear characteristics of the valve?
Or, you are asking how to model that valve in SimScape?
Risposta accettata
Sam Chak
il 25 Mar 2022
Hi @aleena n a
I'm unfamiliar with the triplex mud pump. However, there are various types of valves for fliud flow control in the Simscape library.
The easiest way would be select the relevant valve blocks, and then set the parameters that are usually determined by the type of working fluid (in this case, the mud). The nonlinear characteristics of the valves are also specified in the documentation of each valve.
What are the requirements for modeling a predictive maintenance system?
2 Commenti
Sam Chak
il 25 Mar 2022
Hi @aleena n a
Your task is a model-based design using Simulink. Without any mathematical model, there is nothing much you can do. Perhaps you can try listing out all governing equations related to the following:
- triplex mud pump
- hydraulic valve
- preventive maintenance system
Also check out some examples in
Più risposte (0)
Vedere anche
Categorie
Scopri di più su Multibody Modeling in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!