Info
Questa domanda è chiusa. Riaprila per modificarla o per rispondere.
Command for running l293d through raspberry pi B+ in matlab r2015a
1 visualizzazione (ultimi 30 giorni)
Mostra commenti meno recenti
I want to run motors connected to motor driver ic board l293d. I have assigned Gpio pins 16,20 & 21. In which 16 is enable. My command for running the motors is -
- configureDigitalPin(mypi,16,'output')
- configureDigitalPin(mypi,20,'output')
- configureDigitalPin(mypi,21,'output')
- writeDigitalPin(mypi,16,1)
- writeDigitalPin(mypi,20,1)
- writeDigitalPin(mypi,21,0) Even After giving these commands my dc motor is not rotating. Plz help
0 Commenti
Risposte (0)
Questa domanda è chiusa.
Vedere anche
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!