Azzera filtri
Azzera filtri

Is it possible to use a parameter within the "To Workspace" block?

4 visualizzazioni (ultimi 30 giorni)
I have a "ToWorkspace" block inside a masked subsystem. I would like to change the name of the variable (where the data is saved) based on a parameter of the subsystem mask. Is it possible to do this somehow?
Thanks in advance for whoever helps me.

Risposte (1)

Fangjun Jiang
Fangjun Jiang il 9 Apr 2024
Modificato: Fangjun Jiang il 10 Apr 2024
I remember answering the same question before. The answer is "No" by value passing, but you could do it using set_param().
For MyValue=1, the value (1) of the variable name "MyValue" is passed into the mask workspace. Inside the masked subsystem where "MyValue" is used, it is using the value (1), not the name "MyValue".
But for "To Workspace" block, the variable name "name" itself is used, not the value of the variable name "name".
This sounds confusing but it is the case for a few similar parameters for other blocks.
If you are open to write some lines of code in the call-back of the mask, you could use set_param() to set the variable name of the To Workspace block, based on the name provided at the mask dialog.
What I would suggest is to use other signal logging methods, not to use "To Workspace" block. Basically, select the signal line, right click, select "Log Selected Signals".

Categorie

Scopri di più su Subsystems in Help Center e File Exchange

Prodotti


Release

R2022b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by