pdetool identify boundary nodes
9 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
After exporting mesh nodes in "p" from pdetool to workspace, I should like to identify those nodes which pdetool assumes are boundary nodes.
0 Commenti
Risposte (1)
Alan Weiss
il 7 Lug 2016
I believe that you can get the [p,e,t] representation of the mesh, and then examine the list of edges e. Look at the indices k where e(6,k) or e(7,k) is 0, meaning an edge of the geometry bordering on the exterior. For details, see the mesh data description. These edges have corresponding points p that are on the boundary of the geometry.
Alan Weiss
MATLAB mathematical toolbox documentation
3 Commenti
Alan Weiss
il 8 Lug 2016
PDE Toolbox allows you to set boundary conditions only at edges of the geometry, not internal edges. So perhaps the e matrix consists only of those edges, but I don't know for sure. It might depend on how you created the geometry, whether you removed internal edges or not.
Alan Weiss
MATLAB mathematical toolbox documentation
Vedere anche
Categorie
Scopri di più su Geometry and Mesh in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!