Info
Questa domanda è chiusa. Riaprila per modificarla o per rispondere.
How can we change output state of delay block during simulation ot its initial value using command prompt
1 visualizzazione (ultimi 30 giorni)
Mostra commenti meno recenti
I want to change output state of delay block to initial value during simulation.
This should happen when that subsystem gets enabled.
But I dont want to change "States when enabling" property to "Reset". Is this possible what enable block do we can do using command prompt? So it will change state of output block as same as when enable subsystem "Reset"
0 Commenti
Risposte (2)
Kaustubha Govind
il 16 Ott 2012
If you use the Unit Delay Resettable block, you should be able to reset it using the reset input port instead.
2 Commenti
Kaustubha Govind
il 17 Ott 2012
Could you explain what you mean by: "MATLAB do this in the background depending upon option selected in enable port mask."
AFAIK, that setting cannot be changed during simulation. If you want to do it before simulation starts, you can of course use:
set_param('path/to/enable/port', 'StatesWhenEnabling', 'reset')
If you can't change that block (library block?), then perhaps you could connect another Enable Subsystem at the output of that block and used the solution I suggested here. Use the same initial condition as that for the library block.
Azzi Abdelmalek
il 16 Ott 2012
Modificato: Azzi Abdelmalek
il 16 Ott 2012
if ModelName is your model name
set_param('ModelName/Unit Delay','x0','10')
0 Commenti
Questa domanda è chiusa.
Vedere anche
Prodotti
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!