Failed to program the device of the Zedboard Using matlab R2019b
1 visualizzazione (ultimi 30 giorni)
Mostra commenti meno recenti
Hi.
I am using MatLab R2019b(academic use) and following a video- Run a Simulink Model on Zynq: ZedBoard Set Up” showed on MathWork with an example of “led_blinking” to setup my Zeboard FPGA board(zynq 7000).
- When I was running the step 4.3 – Build FPGA Bitstream, a window of Command Prompt was openned simutaneously and the results of the HDL Workflow Advisor was showen “passed” showed as the figure. Is that correct?
- When I was running the step 4.4– Program Target Device, the results shows “Failed Too many output arguments”. How can I fix the problem ? Dose the HDL Workflow Advisor have a Debug function that I can use to debug my design ?
0 Commenti
Risposte (1)
Kiran Kintali
il 23 Lug 2020
Hi Yuhwai, This is unexpected. Please report the issue to support@mathworks.com for further support.
Vedere anche
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!