Community Profile

photo

Tasin Nusrat


Last seen: 9 giorni fa Attivo dal 2021

Statistics

  • Thankful Level 2

Visualizza badge

Content Feed

Visto da

Domanda


Trying to plot the multiplication of triangular and unit step signal.
I am trying to plot a signal x(t) where x(t)=0 for t<0 x(t)=0 for t>=1 x(t)=-t+1 for 0≤t≤1 I write the code as follows: ...

2 mesi fa | 1 risposta | 0

1

risposta

Domanda


How can I read a column from excel while I do not want all the data of that column?
I want to plot four graphs in the same figure. I can read all of them from excel. But for first plotting i want to plot all the ...

3 mesi fa | 1 risposta | 0

1

risposta

Domanda


I am stucked while plotting time discrete for the inverse z transfer.
I want to plot the time discrete sequence for the below transfer function: F(z)=z/(z-0.5)(z-2) I have written the below code. ...

10 mesi fa | 1 risposta | 0

1

risposta

Domanda


Need help to plot the time sequence associated with the below inverse transfer function
F(z)=1/(1+z^-2) ; IZI>1 I have computed the above equation for f(k), can I plot the time sequence associated with this transfo...

10 mesi fa | 0 risposte | 0

0

risposte

Domanda


Is it possible to solve difference equation in MATLAB?
Can I solve this below difference equation using Matlab? y(k)-3y(k-1)+2y(k-2)=2u(k-1)-2u(k-2) u(k)=k when k>=0 and u(k)=0 when...

10 mesi fa | 3 risposte | 0

3

risposte

Domanda


how to get an impulse response rather than a sine wave?
If I don't want to connect my output data as wave, rather want to connect each output for the respective inputs, how should I su...

circa un anno fa | 1 risposta | 0

1

risposta

Domanda


How can I take an integer like n=1:1:50 and get the output for each value?
I want to plot my output for each input and the input is from 1 to 50, but I am not sure why my code is not working. n=1:50; ...

circa un anno fa | 2 risposte | 0

2

risposte

Domanda


solve the equation for a large frequency range
I want to solve the below equation for the frequency range of 1Khz to 100MHz. the equation is factor=Rsh/(Rsh+j*2*pi*frequency...

circa un anno fa | 1 risposta | 0

1

risposta

Domanda


How can I use xticks with a bigger range of values towards x axis
The X axis have the range of 1khz to 100Mhz with ticks at 10khz,100khz, 1Mhz, 10Mhz. freq=1e+3:1e+8; %frequency range ...

circa un anno fa | 1 risposta | 0

1

risposta